Use and Care of Adult Sex Dolls


Instructions for use and maintenance

1. The outer layer is made of high elastic property coupling TPE (thermoplastic elastomers) epoxy resins with firm body support and finely worked skeleton. All materials comply with national standards of health and safety which is harmless to humans and are environmentally friendly.

2. The skeleton and joints allow the model to pose in many positions and styles. With a little imagination, it can be very human. For durability, do not put in positions highly stretched over a long period of time. Although the elasticity of the material of TPE is wonderful, overstretching for long periods of time could lead to deformation. Please reposition the model to its original position, hands resting down after use.

3. It is a standard procedure during manufacture to assemble and position your skeleton in the precise points. Join several media during the injection process, therefore there will be some small fills these holes are not classified as manufacturing defects.

4. Avoid sharp objects or knead with excessive force.

5. Strongly advice to test the fading colors of clothing worn earlier in the model. Must have particular signal fading dresses, please do not use a model as spot could hardly be eliminated. We will not be responsible for its consequences.

6. No model exposed under sunlight for a long period of time. This could increase the aging of TPE materials and life goes on model.

7. If folds or pressure mark occurs, can be applied hot towel to the wrinkled area.

8. Dust and dirt can be cleaned with regular detergent washing machine, dishwasher or bath foam. Clean gently with the palm and care of fingernails and thick materials that may affect or scratch the surface. When it dries, apply powder with powder or cornstarch established. Model will be as good as new again. It is highly recommended periodic maintenance of your model.

9. If zero experienced its surface modeling, cut or thrust, please use glue to seal TPE supplied. defected area clean with makeup remover before pasting. Make sure the surface is not defected tension when TPE glue is applied. The curing time is approximately half an hour.

If you have any further questions on technical issues or maintenance model, please do not hesitate to contact the vendor for more help

5/5 - (5 votes)
Categories: Sex Dolls


Leave a Reply

Avatar placeholder
error: Content is protected !!